Battery Connector Busbar Set
2 x Bolts
2 x Spring Washers
2 x Washers
1 x 3mm thick Aluminum Connector
R 25.00
R 17.50
you save 30%
Built Unit Battery Monitor cable
Download Driver Download BMS Monitor ( BMS firmware version 2.8 and lower) NEW Download BMS Monitor (BMS firmware version 16.4 and higher) Download and unzip the driver as Below Install...
R 150.00
LiFePo4
RJ45 Network Cable 2M
RJ 45 Network Cable Used for Parallel connection of LBSA Built units. CANbus Communication between LBSA Built units and CAN ports on DEYE, Sunsynk, Growatt, and new versions of Luxpower...
R 50.00
LiFePo4
Seplos 100A 16S Smart ESS BMS
Technical Parameters Continuously charging/discharging current 100A Communication protocol CANBUS(default) Working Temperature -20℃-70℃ Pre-charging 0-3000ms Current limiting(charging) 10A Current Balance ( Passive Balancing) 150mA(Max) Power consumption Working mode power consumption =...
R 4,000.00
LiFePo4
RJ45 Network Cable 1M
RJ 45 Network Cable Used for Parallel connection of LBSA built units. CANbus Communication between LBSA Built units and CAN ports on DEYE, Sunsynk, Growatt, and new versions of Luxpower...
R 35.00
LiFePo4
Grey LUXPOWER to LBSA communication cable 2m
Grey LUXPOWER to LBSA communication cable 1m (only suitable with old versions of Luxpower Inverters) Pinout ...
R 75.00
LiFePo4
Grey LUXPOWER to LBSA communication cable 1m
Grey LUXPOWER to LBSA communication cable 1m (only suitable with old versions of Luxpower Inverters) Pinout ...
R 50.00
LiFePo4
Grey LUXPOWER to LBSA communication cable 1,5m
Grey LUXPOWER to LBSA communication cable 1,5m (only suitable with old versions of Luxpower Inverters) Pinout ...
R 60.00
LiFePo4
5.1kwh battery enclosure with 100A smart BMS and 125A breaker
This enclosure is a nice upgrade if you purchased one of our DIY Kits with 100Ah cells.
Measurements:
420x326x190
R 4,000.00
LiFePo4
5.1kwh battery enclosure
This enclosure is a nice upgrade if you purchased one of our DIY Kits with 100Ah cells.
Measurements:
420x326x190
R 150.00