120a, peak 320a 7-16s Li-Ion and LiFePO4 ANT Smart BMS With Bluetooth and LCD

LBSA BMS 120A 4S 12V LifePO4 Lithium Ion Phosphate

LBSA BMS 120A 4S 12V LifePO4 Lithium Ion Phosphate

LBSA BMS 120A 15S 48V LifePO4 Lithium Ion Phosphate

LBSA BMS 120A 15S 48V LifePO4 Lithium Ion Phosphate

R 2,500.00
Availability: Out Of Stock
-
+
Will Prowse Youtube Video: Link
iphone app you can search " ANT bms " in app store.
Android APK Download: Link 1 |  Link 2
Features
Charging current: 50A
Equilibrium current: 100MA
Connection mode: same port
Size: 14 * 7 * 1.7CM
Unit voltage: detection range 1-4.6V, accuracy is less than 5MV
Overcharge and over discharge: protected
Working voltage: 15-80V
Short circuit protection: short circuit protection current can be set
Bluetooth connection: for Android phones
Applicable battery: ternary 7-16S iron lithium 8-16S
Coulomb meter: Based on the current and time score, accurately
calculate the remaining battery capacity, the error range is less than 5%
Power consumption: 3MA during operation, 1.5MA during standby
External temperature sensor
Temperature sensors
This model can only connect 2 temperature sensors
The two temperature sensors are connected and not connected, and the protection board can work normally.
The temperature sensor is not connected, and it is normal to display -30 degrees with Bluetooth.
After the protection board is connected to work normally, then connect the temperature sensor.
After the sensor is connected, it is best insulated with a heat shrink tube.
The back is fixed with double-sided tape
T1 and T2 are placed in two different positions of the battery pack to detect the temperature
ANT BMS
Protection board startup instructions
First, the protection board needs to connect all the wires according to the corresponding string number connection diagram, and then follow the figure below:
4P socket has two wires, one red and one black
The red is connected to the positive electrode of the battery, the black is connected to the negative electrode of the battery. It needs to be shorted to a voltage of 3-5V. Shorting it to 2S will turn on the battery. It can be connected to a single battery or any string of voltages in the battery pack. After the protection board is powered on, red lights at both ends flash, indicating that the protection board has been powered on. After powering on, disconnect the two wires. You can also leave the two wires for emergency use after power failure.
The protection board is connected to all the wires, and can be directly plugged into the charger to activate the boot, but some chargers may not be activated.

Start BMS

ANT BMS

Screen Connect

ANT BMS SCREEN CONNECT

Connection Diagram

ANT BMS CONNECTION DIAGRAM